Modular Wheelchair Ramp is made to make it simple for persons with disabilities who use wheelchairs to cross any type of elevation difference, including steps, thresholds, and vehicle entries.

Modular Wheelchair Ramp is quite simple to setup. With bolts (DIN-1651) and wing nuts (DIN-315), the support legs are fastened to their numbered locations on the ramp (and any landing, if any). No modifications to the architectural texture are required.

Modular Wheelchair Ramp is constructed of steel and aluminum alloys. Modular Wheelchair Ramp is not corroded (rusting, tarnishing, etc.) due to its scratch and impact resistant coatings. It may be used in any weather situations, both indoors and outside. Modular Wheelchair Ramp is even seawater resistant.

The wheelchair can move freely without slipping or shaking thanks to its precisely designed gear surface. Grid areas are made to be usable for both walking and cane use. In any weather situations (snow, rain, mud, icing, etc.), it is incredibly safe to use.

Modular Wheelchair Ramp is typically created with a maximum width of 80 cm. (Power chairs and other wheelchairs are 65 cm broad.) Depending on the demand, they can be produced in the 60–120 cm range.

Modular Wheelchair Ramp weighs 7kg per meter.

Modular Wheelchair Ramp affects the load carrying capacity in a variety of ways. 600 kg can be carried safely on 1mt Modular Wheelchair Ramp. To keep them from straining, ramps longer than 1.5 meters are supported by practically detachable legs.

On either side of the Modular Wheelchair Ramp, there are 5 cm high safety barriers that stop the wheels from swerving off the side of the ramp. It is also appropriate for installing railings.

Numerous wheeled vehicles, including bicycles, motorbikes, ATVs, and lawn mowers, can also be loaded with ease.